Freehand Fashion: Asymmetrical peplum jacket

Hello all! I'm really excited to be part of the blog tour for Chinelo's new book: Freehand Fashion. It's primary purpose is to show sewers how to draft things straight onto fabric without using a pattern. It was a very interesting technique for me to try and to compare to the flat pattern drafting and draping on the stand that I've learnt at uni in the last month or so.

Basic sewing techniques feature at the beginning, followed by a handy measurements table that you can write your measurements into. I found the diagrams really useful to show me where each measurement should be measured from which made them as accurate as possible. I recommend double checking them, because if they aren't accurate your finished garment will not fit as well.

There are 15 projects in the book of various difficulties using either the bodice block, dress block, flare block or sleeve block as a base. I chose to make the asymmetrical peplum jacket as I was in the market for a new coat as it's getting colder. Fabric needs are noted separately for each pattern piece which makes it a bit of a faff to work out how much you need in total. Although if you were planning colour-blocking it's really useful. I guessed 2.5m and I used about 1m less than that, though I did reduce the flare in the peplum.

And here is my finished jacket! It is somewhat inspired by Diors famous 'new look' although I couldn't quite achieve the corseted silhouette which makes his design look so sharp. I purposefully took out most of the flare, making it 1/4 circle instead of the full circle, my reasoning being that it would be more wearable with fuller skirts. I kept it symmetical but now I look at the pictures, I think it would look really good if it was asymmetrical. I do think it needed a little more fullness for it to sit better around the hips.

The instructions for the jacket tell you which steps of the bodice block are relevant for this project. The sleeve block and the flare block were also used. I did all the drafting on paper so if there were any adjustments needed they would be easier to apply to the outer fabric (I used the lining as a mock up). I did have to recut the sleeves because I got the measurements completely wrong.

Fitting wise, there is some excess fabric at the back armhole and the shoulders are too wide but I'm really pleased with the fit of the front bodice especially. Although more ease would need to be added if I wanted to wear more than one layer under it.

I love the massive collar,, although it would be interesting to see whether it would behave differently if cut on the bias.

Finishing wise the jacket is fully lined in a contrasting black lining. I lugged my sewing machine home for the weekend (I had to go back to get my braces tightened, joy of joys) and only realised when I got there that the cable was sitting on my desk in my uni room! So I had to construct the outer of my jacket using the overlocker and sew the hem and armholes by hand because I then ran out of overlocker thread. I used poppers to fasten the jacket for a more streamlined look. There is a running stitch down each side of the lining which it needed to keep it from peeking out.

All in all, it was really interesting to try a new way of drafting patterns. It's definitely quicker to do than the flat pattern drafting method I've been taught. I think it may be more straightforward to follow if you have no drafting experience because I kept second guessing the instructions, and actually if you just follow them, surprise surprise, it works!