Floral Tank Refashion

Hello all! Today's make is a refashion of a top I made all the way back in 2013. It was supposed to be a 5 minute jobby but turned into a one day saga. The neckline on the old top was too high which meant that it didn't get much wear and I decided that it was time to give it a makeover for my upcoming solo trip to Amsterdam next week (argghh!)  
I originally put the top on my dress form, pinned where I wanted the new neckline and straps to be, but that ended up just being a bit of a disaster. So then I went to my trusty pattern stash and dug up Simplicity 5461 (the dress pattern not the bear pattern) and used the tank pieces as a guide for a new neckline and armholes. After I cut the new neckline and armholes I realised that the neckline was far too low, revealing pretty much everything that shouldn't be revealed. I had 2 options: throwing it into the corner of the room and never speaking to it again, or just sticking back on the bit of the neckline that I had just cut off.
I went with option 2 because without it my Amsterdam capsule wardrobe would be nothing. So, off to the ironing board I went, butted the bit of the neckline that I had just cut off to the top with some interfacing underneath and ironed it into place. Then I was just left with some raw edges to hide. After a rummage around my ribbon drawers I found this vintage lace trim which I think was handworked by one of my Mums friends Mothers. It was a perfect accent to a pretty simple top.
I could have left the trim on just the front of the top, but the shoulders were a bit wide so I used the trim across the shoulders to keep them in place, crossing them at the centre back. The back neckline I kept the same as the original low neckline so you can imagine where that would sit on my front. The side seams were already French seamed and the hem turned up twice which saved me some time. The only finishing I had to do was silk bias binding around the neckline and armholes. It ended up pretty short due to all of the chopping, but it's a perfect length with these jeans. I'm sad that summer is over so I can't wear it as much as it deserves.
Thanks very much for reading and to Ed for the photos!
Lauren xx

Summer ball dress 2017

 Hello all! I've finally managed to get some pictures of my Summer Ball dress so let me tell you its story. I'll paint a picture for you: It's the end of the university year. Money has trickled out of the bank account until mere drops remain. There is no budget for fabric. There is no budget for alcohol. In these sad times one must make do and mend. I had two options. Option 1 was to make some kind of dress with the floral scuba I made my bikini from. Option 2 was to whack a bodice onto my gathered silver circle skirt, made a few months ago. I decided that now was the time to go big and have some fun.
I was told in no uncertain terms that top-to-toe silver would be too much, and turn me into the tin man from Wizard of Oz. In fact, this turned out to be quite a popular opinion. But, I had a vision and I was determined to see it through.
 In terms of construction for the midriff panel I used the pattern piece from Wearing History's Dahlia top pattern and I started off with 2 long triangles for the bust covering pieces. I first slipstitched the bottom of the midriff panel to the bottom of the existing skirt waistband. Then I put on the skirt, pinned the tops of the 2 triangles together to form a halterneck and tucked the ends of the 2 triangles into the skirt. My dear friend Bethan then plonked in the safety pins to determine the neckline, sidelines and attaching the bust bits to the midriff panel. Next I detached the bust bits, made the adjustments, lined them with some black chiffon I had lying around and sewed them onto the midriff panel.
Since the skirt was already finished, the bodice part really didn't take very long, although I would have really struggled with the fit without Bethan's help (Thank you Bethan!) It's certainly not a quiet piece of clothing, but then I'm not a very quiet person so perhaps we match each other quite well. The full skirt in particular was very good for the pimms induced dancing.
Thanks for reading and to Ed for taking pictures!
Lauren xx

Floral scuba Sophie bikini

Hello all! Today I'm going to share this years Sophie bikini with you. You can see last years here and this year I even managed to replace the pint sized paddling pool with the real deal! My friend thought I was braving the 7 hour Megabus to Wales for her but it was actually for those sweet sweet seaside pics.
This year I actually managed to acquire some foam (for the princely sum of £12.50 for half a metre) which was very painful to hand over the money for at the till seeing as I only needed 10cm worth. Let's say it's an investment for my next 10 years of bra/swimwear making. I also bought proper rubber elastic for the first time. Of course I failed to purchase enough, so had to make do with clear elastic for the rest. I only remembered about swimsuit clasps when I got home, so I stole this one from last years bikini.
 The pattern for the bikini bottoms was my standard pants pattern which was originally copied from one of my existing pairs of pants. Now I attempted to account for the fact that I was making these in scuba by adding 1cm to the waistline WHICH WAS NOT ENOUGH. Hence the added panel at the top. According to my Mother they look a bit tight, and as per, she is right. Probably should have sized up all over. They aren't circulation-cutting-off-tight though so perfectly wearable.
 In terms of the bikini top I had a few issues. Mostly because I'm an idiot and used the pattern pieces I had when testing the pattern before they were altered for the final version. I made a couple of  test versions of different cup sizes in the foam to double check sizes before committing to the fabric. I had SO much fun butting the edges of the foam together and zigzagging. Talking of fabric, I used scuba because it's what I had. I couldn't find any existing Sophie's made from scuba but it has been used by various people for underwear so I decided that was enough to go ahead. I ended up going up 3 cup sizes mainly because the foam lessens the stretch (I think?), pinched a bit of the gaping at the top cup out, recut and took some width out of the bridge to get what you see before you today.
Said Welsh friend received a very up close and person video call to help me assess all aspects of fit. (Cheers MK.) Although it took a bit of trial and error to get it just right I'm pretty happy with what I've ended up with. It survived an (admittedly short) session of snorkelling, and what more can you ask of a swimsuit? The bridge doesn't lay flat but I'm not sure if that's because I didn't put wires in or if my boobs aren't big enough or if the fit is just wrong? Or maybe all 3. Anyway, it's the nicest bikini I've ever owned.
Thanks very much for reading and to MK and Paul for the photos,
Lauren xx

Ruffle Wrap Skirt

Hello all! Today I have a new skirt to share with you. It's not the quietest of skirts. In fact I'd go as far as to say that it makes quite a statement. I haven't quite decided whether I like the statement it makes or not, so please leave thoughts and opinions in the comments!
First lets talk about the fabric. This is a cotton that I crinkle dyed with flour not one but two whole summers ago. It was originally intended for a coat, but then I came to my senses and realised that there was in fact nothing less suitable to make a coat out of and so it was shelved until another million dollar idea hit. The million dollar idea didn't hit until a few months ago when I read this blog post. I loved the drama of the skirt and decided that I needed my own. A quick peruse of the stash led me to this beauty and I got cutting.
 I used a vintage wrap skirt pattern that I unfortunately can't name because I left it in London (I'm finally home for the summer, yay full fridge!) I cut the skirt with a high low hem and then added a massive gathered rectangle for the ruffle. A pro tip is to hem the gigantic rectangle before you attach it to the skirt. It turns out that the hem had quite a big circumference so the gigantic rectangle wasn't quite as gathered as I would have liked, but you've got to work with what you have.
 The skirt is simply wrapped around the body and tied at the side. I learnt on the walk to uni that there is a reason why there is a button to secure the wrap on the other side, because if it is not secured it will fall down and you will almost flash the world just when walking past the local primary school. I haven't finished the ruffle seam edge yet because I can't quite decide what I think of it. Is it beach appropriate only or can I somehow incorporate it into my summer wardrobe?
Anyway, thanks for reading as always. I hope that you are all having lovely summers/winters wherever you are. Thanks to Paul for the photos and MK for directing. We got some cracking poses in there.
Lauren xx